| Training
By Console: |
|
|
|
|
| Training
By Topic: |
|
|
|
|
|
|
|
| External Links: |
|
|
|
|
| Replacing
a Hog iPC Hard Drive (SATA or IDE) |
Before
beginning, follow
these instructions:
- Disconnect power to the console
- Disconnect all monitors, external devices
keyboards,
widgets, etc.) and remove the main console portion from the roadcase.
Note: Some iPCs contain a SATA HDD while others contain an
IDE HDD.
Be sure to replace with the correct model of hard drive.
You can see a picture of each HDD connection at our GLOSSARY page.
Opening the
Console: |
|
|
1.
Use a 4mm hex key to remove the 4 silver screws holding the front panel
in place (encoder wheels and fader caps need not be removed).
|
|
2.
Gently lift the front panel PCB (circuit board) as you would
a
car hood (there are connections at the top of this board that can be
damaged if you pull straight up). Please note that this
circuit
board is not hinged to the console.
|
|
|
| 3.
Disconnect the cables from the front panel PCB set the front panel
aside. ***Note where each one will be replaced when
rebuilding
the console. |
|
|
|
Removing
the old HDD: |
|
|
| 4.
Disconnect the cables from the CD
drive and the hard drive. Hard drive is located beneath the
CD drive. Both drives are mounted in the same retainer.
The CD drive has 3 connections and the hard drive has 2
connections. |
|
|
5. To
remove the HDD/CD drive
retainer, carefully raise the console up and remove the 4 screws on the
right half of the underside of the desk. Use caution so that
the drives do not fall out, or cause damage to the other PCBs inside
the console.
|
|
|
| 6.
Remove the CD drive and the
hard drive from the console carefully. |
|
|
| 7.
Using a phillips head
screwdriver, remove the 4 screws holding the old HDD in the retainer
mount. |
|
|
|
|
